Ways to Deal Blocking of FTM Hammer Mill Crusher

Either for the field of metallurgy or for the field of mining, crushing work is indispensable. After the crushing work, mineral ores will have two forms of powders and pellets. Mineral powders, being produced by hammer crusher, sometimes may cause the blocking problem or even influence the working efficiency and service life.

To solve these failures, you need to design the newly-type crushing system. At present, crushers that be commonly used for the crushing work are hammer crusher or jaw crusher, etc. Problems that may cause the blocking of crushers are in two aspects. For one aspect, hammer mill crusher has something wrong with the design process.

If the hammer crusher is purchased at early period, it will be more backward than that at current times. Confronted this situation, you should purchase another new hammer crusher. For the other aspect, failures of hammer crusher may be related with the unskillful operation of operators. Known as the NO.1 brand of hammer crusher, FTM Crusher Company hopes to work with you in the future. 

During the working process of hammer crusher, operators should notice the deflecting angle of ammeter pointer. If dynamo current is higher than the rated value, dynamo will be overloaded and burned out. Confronted with this situation, you should immediately cut down or close the feeding door.

To help you do the feeding work better, FTM Crusher Company equips the hammer mill crusher with feeder, which can control the feeding amount and speed. To alleviate the blocking problem, FTM Crusher Company has done a lot of efforts to improve the design of crushing system and change the material flow. Surprises for you on website!